Close
Control modules | Measuring modules | Pumps | Small items
GSU module for programming all engine operating parameters entered into the ECU HORNET III module.
It is also used to control turbine operation during tests and service works.
The extensive configuration menu allows you to precisely control all engine parameters in the version with gas ignition and liquid fuel (kerostart). • Control of the fuel pump, valves, starter, glow plug or flame. • Full control over engine operation parameters. • Choice of rotor speed counting version by optical or magnetic measurement.
• Turbine operation time and emergency events registration. Possibility of cooperation with telemetry and GPS module.
Selection of supply voltage in the range up to 12Vdc.
The extensive configuration menu allows you to precisely control all engine parameters in the version with gas ignition and liquid fuel (kerostart). • Control of the fuel pump, valves, starter, glow plug or flame. • Full control over engine operation parameters. • Choice of rotor speed counting version by optical or magnetic measurement.
• Turbine operation time and emergency events registration. Possibility of cooperation with telemetry and GPS module.
Selection of supply voltage in the range up to 12Vdc.
Gear pump for supplying engines with JET A1 fuel with a nominal operating pressure of 7 bar (max 8 bar). Adapted to all GTM series engines. The pump is covered by a 24-month manufacturer’s warranty. Standard hydraulic connection – 4mm, electric – MPX plug. It is not suitable for pumping water.
